top of page
R885.jpg

R885 DRAWER BOX CLAMP

  • 14″ x 24″ x 36″ Capacity

  • Pneumatic Controls

  • (2) 4″ Bore Clamping Cylinder

  • Box Alignment Stops

  • Operator Control Panel

  • 40″ X 72″ Floor Area Required

  • Designed And Manufactured In The United States

​

The R885 Drawer Box Clamp was designed for dovetailed and doweled cabinet drawer box assembly. The R885 easily adjusts for the width/length of the product. Rigid square end plates keep equal pressure across the face of the box while being pressed. Easy adjust finger blocks keep the edge of the box aligned parallel to the system.

R853.png

R853 HORIZONTAL/VERTICAL

LINE-DOWEL DRILL / DRAWER DRILL

  • Foot Actuated Drilling and Clamping Cycle

  • (13)-Spindle Gear Head

  • 32mm Spindle Centers on Gear Head

  • (7) Right Hand, (6) Left Hand

  • 10mm Bored Collets

  • 2 HP Spindle Drive Motor, TEFC

  • 0-2″ Adjustable Boring Depth Turret

  • 1/2″ – 3/4″ Thick Drawer Box Sides

  • 14″ Maximum Drawer Box Height

  • 12″ X 24″ Machined Steel Work Table

  • 34″ Work Height

  • Horizontal / Vertical Boring Fence System

  • Horizontal / Vertical Material Clamp System

  • Wired 3-Phase 230 Volt, 60 Hz.

  • Tooling Not Included

  • Designed and Manufactured in the USA

  • Additional options for this machine include:

  • E55 – 1.5 HP 1-Phase Motor, 220 Volt

​

The Ritter R853 is a robust 13 spindle horizontal borer, designed to provide for fast and accurate horizontal and vertical boring for drawer boxes. The operation sequence helps eliminate costly mistakes and rejected parts, and it helps increase production and efficiency. Ideal for drawer assembly, and other functions for the clean and accurate drilling of wood components. The machine is equipped with a universal clamping system requiring no set-up change from horizontal to vertical boring. The workpiece is held firmly against the table by a pneumatic clamps, and there is full adjustability of the index stops, bed height, and depth of cut.

bottom of page